VINICOR®-acryl-14

DESCRIPTION

One-pack enamel based on acryl-siloxane resins (with biocyde additives as agreed with the customer). It is resistant to atmospheric agents, including UV radiation.

RECOMMENDED USE

It is used as a protective coating for concrete and other mineral bases exposed to the industrial atmosphere, mechanical wear and abrasion.

It forms a hard, wear-resistant coating.

It is used as:

•  an independent coating;

•  a finishing layer with VINICOR-acryl-013.

CERTIFICATES, APPROVALS

State registration certificate No. RU.77.01.34.008.Е.001467.06.19 dated June 24th, 2019

Approved by the test center AO TSNIIS.

SURFACE PREPARATION

• remove dirt, oil and grease;

• remove lime (cement) milk, damaged or peeling concrete layers and old coating with abrasive cleaning, grinder or brushes;

• remove dust;

• repair cracks and chips.

The concrete surface prepared for the paintwork application must be evenly rough and free from protruding reinforcement, cracks, pits, shells, sags, chipped edges, oil stains, dirt and dust.

The holding time of the concrete base before primer application is to be at least 28 days; after using leveling compounds – in accordance with the regulatory documents of the compound manufacturer. Surface moisture (in the surface layer with 20 mm thickness) not more than 4%.

When applied in a complex coating with VINICOR-acryl-13 as a finishing layer (or when applying enamel in several layers), the surface of the underlying layer must be dry, clean and free of oil and dust.

STORAGE AND HANDLING

The material is supplied in metal buckets.
Storage conditions in accordance with GOST 9980.5 (at ambient temperatures from minus 40 to plus 40 °С). The container with material components must not be stored near hear sources and exposed to precipitation and direct sunlight.
Guaranteed storage life: 24 months from the date of manufacture.

PRECAUTIONS

When working, one shall observe the corresponding industrial standards, requirements and safety measures indicated on the container label.
Use personal protective equipment (goggles, masks, respirators), avoid inhalation of thinners during evaporation and contact of the material or its components with skin, eye and respiratory ways mucous membrane; use the material indoors only with sufficient ventilation.

Material and its components are flammable!