EP-0010 filler

DESCRIPTION

Two-pack epoxy filler. Can be applied in a thick layer up to 2 cm thick without streaks and sags.

PURPOSE AND AREA OF APPLICATION

Designed for application on primed and non-primed surfaces made of steel, fiberglass, carbon fiber and/or other rigid materials for coating systems and/or as an independent coating used in sea and fresh water, atmospheric conditions and indoors.

CERTIFICATION, TESTS

State registration certificate No. RU.77.01.34.008.Е.002967.11.20 dated November 3rd, 2020

SURFACE PREPARATION

preparation

Metal or steel surface:

• degreasing the surface;

• abrasive blast cleaning to grade 2 according to GOST 9.402 or Sa 2 ½ according to ISO 8501-1 or power-driven or manual tool to grade St3, St2 according to ISO 8501-1;

• removing dust

Fiberglass and carbon fiber surfaces:

• degreasing the surface;

• abrasive cleaning to make the surface rough;

• removing dust;

Primed surfaces:

• degreasing the surface;

• abrasive cleaning to make the surface rough;

• removing dust.

The materials should be delivered as a set: the base and hardener packed in metal buckets and cans, respectively, depending on the weight.

Storage conditions in accordance with GOST 9980.5 (at ambient temperatures from minus 40 to plus 40 °С). The container with material components must not be stored near hear sources and exposed to precipitation and direct sunlight.

Guaranteed storage life of the hardener: 12 months from the date of manufacture.

SAFETY MEASURES

When working, one shall observe the corresponding industrial standards, requirements and safety measures indicated on the container label.

Use personal protective equipment (goggles, masks, respirators), avoid inhalation of thinners during evaporation and contact of the material or its components with skin, eye and respiratory ways mucous membrane; use the material indoors only with sufficient ventilation.

The material and its components (the base and hardener) are flammable!