ISOLEP® primer/finish

Description

ISOLEP is a two-component high-build fast-drying polyamine cured epoxy primer/finish with high dry residue. Reliable protection is achieved by filling with an anti-corrosion pigment (zinc phosphate), the action of which is enhanced by an organic corrosion inhibitor.

It forms a thick coating and is especially recommended for application in plant conditions.

Recommended use

Anticorrosion protection of metal structures operated in the atmospheric conditions of all macroclimatic areas, types of environment and placement categories in accordance with GOST 15150.

ISOLEP is recommended for application

• as a single coating system in conditions of open industrial atmosphere and indoors in the absence of special requirements to decorative properties;

• as a primer with VMP coatings POYTON-UR (UV) and VINICOR-62; with fire-proof PLAMCOR series coatings, as well as with other acrylic, polyurethane and other top coats.
  

Certificates, Approvals

Certificate of state registration No. № RU.66.01.40.008.Е.000031.07.24 dated 25.07.2024.

Approvals: Institute of Applied Chemistry and Certification Frishberg

Surface preparation

• to degrease metal surface to 1 grade according to GOST 9.402;

• abrasive blast cleaning to 2 grade according to GOST 9.402 (Sa 2 ¹/₂ ISO 8501-1).

In tight areas it is permitted abrasive blast cleaning to 3 or 4 grade according to GOST 9.402 (St 2 ISO 8501-1);

• to remove dust.

Before the application of top coats, the primer/finish coating ISOLEP must be decontaminated, degreased and dustless.

Application

• mix the base to a homogeneous condition before application;

• add the hardener, mixing ratio by volume 3:1, respectively, after mixing, the primer is ready for application;

• dilute with the thinner to the working viscosity immediately before application, if necessary.

ISOLEP shall be applied at plant and field conditions at temperatures from minus 10 °C to plus 40 °C and relative air humidity not exceeding 85 %.

The temperature of the primer during application should be not less than 15 °C to ensure necessary processing characteristics.

If the maximum time is exceeded and the structures are stored for a long time under the influence of sunlight, additional measures are necessary to improve the adhesion of the layers of the top coats – treatment of the coating with ISOLEP using detergent MS-01 (TS 2381-095-12288779-2013).

Storage and handling

ISOLEP is supplied as the Base and the Curing Agent in metal containers.

Storage conditions – in accordance with GOST 9980.5 (at air temperature from minus 40 to plus 40 °C). The material components shall be protected from direct sunlight and atmospheric condensation.

Shelf life of the components - 24 months starting with the manufacture date.

Precautions

When working with ISOLEP, the existing sectoral standard norms and requirements and safety measures as specified on the package label shall be observed.

Personal protective equipment (goggles, face masks and respirators) shall be used, and inhalation of thinners and contact of the composition substances with skin, ocular mucosa, respiratory channels shall be avoided; use inside the premises is allowed only in case sufficient ventilation is provided.

ISOLEP is classified as a fire-hazardous material. 

The information is of general character, without consideration to the object specific nature. Use of materials for other purposes not specified here or in case other influencing factors are present shall be approved by the  VMP Holding CJSC  in writing. In case of absence of such approval the manufacturer is not held liable for the improper use of the material and the buyer falls from the right to present claims connected with the coating quality.